RESEARCH REVIEW ON APPLICATION OF HYDROCYCLONE IN WASTEWATER TREATMENT
-
摘要: 水力旋流分离器具有分离效率高、简单可靠、绿色经济等优点,被广泛应用于各种分离场景,特别是近年来在水处理领域得到诸多关注。概述了运行操作参数(进料流速、进料浓度、进料压力)、结构设计参数(溢流管插入深度、底流管直径、回流角)、旋流器构型种类(W型、抛物线型、圆柱形)对水力旋流器分离性能的影响。优化操作参数可增强水力旋流器分离效率;溢流管插入深度与圆柱体横截面直径比值(L0/D)为1.0时产生的流场更有利于分离;底流管直径存在最佳设计范围;旋流分离器与水源热泵联用吸入角为90°时效果最好。水力旋流器的分离作用在水处理过程中可以起到改善微生物聚集体性能(如提高污泥水解速率、提升沉降性能)、分离特定颗粒态微生物(如厌氧氨氧化菌颗粒污泥)、去除或回收特定密度物质(如悬浮有机物、泥砂、金属颗粒)等诸多作用,为水力旋流器在水处理领域的应用拓展了新的前景。Abstract: Hydrocyclone separators have advantages of high separation efficiency, simplicity, reliability and low cost, which has been widely used in various separation scenarios, especially in wastewater treatment in recent years. This article reviewed the operating parameters (feed flow rate, feed concentration, feed pressure), structural design parameters (overflow pipe insertion depth, underflow pipe diameter, reflux angle) and configuration types (W type, parabolic type, completely cylindrical type) on the hydrocyclones separation performance. Optimizing the operating parameters could enhance the separation efficiency; the flow field generated when the ratio of overflow pipe insertion depth to cylindrical cross section diameter (L0/D) equaled 1.0 was conducive to separation; the underflow pipe diameter had an optimal range; combining with water source heat pump, the optimal suction angle was 90°. The recent progress of hydrocyclone research and application included promoting microbial aggregates (including increasing sludge hydrolysis rate and improving sedimentation performance), separating specific particulate microorganisms (including anaerobic ammonia oxidizing bacteria granular sludge) and removing or recovering substances with specific density (including suspended organic matter, mud sand, metal particles), which opened up new perspectives for hydrocyclones future application in wastewater treatment.
-
[1] TIAN J Y,NI L,SONG T,et al.An overview of operating parameters and conditions in hydrocyclones for enhanced separations[J].Separation and Purification Technology,2018,206:268-285. [2] VEGA-GARCIA D,BRITO-PARADA P R,CILLIERS J J.Optimising small hydrocyclone design using 3D printing and CFD simulations[J].Chemical Engineering Journal,2018,350:653-659. [3] 赵立新,蒋明虎,孙德智.旋流分离技术研究进展[J].化工进展,2005,24(10):1118-1123. [4] 隋元伟,贾广如,许高洁,等.水力旋流器研究现状及其在煤化工废水处理中的应用前景[J].过程工程学报,2019,19(2):235-245. [5] HE F Q,WANG H L,WANG J G,et al.Experimental study of mini-hydrocyclones with different vortex finder depths using Particle Imaging Velocimetry[J].Separation and Purification Technology,2020,236:116296. [6] TIAN J Y,NI L,SONG T,et al.Numerical study of foulant-water separation using hydrocyclones enhanced by reflux device:Effect of underflow pipe diameter[J].Separation and Purification Technology,2019,215:10-24. [7] FU S C,HUA W J,YUAN H X,et al.Study on the light medium separation of waste plastics with hydrocyclones[J].Waste Management,2019,91:54-61. [8] NIAZI S,HABIBIAN M,RAHIMI M.Performance evaluation of a uniflow mini-hydrocyclone for removing fine heavy metal particles from water[J].Chemical Engineering Research and Design,2017,126:89-96. [9] 王升贵,陈文梅,褚良银,等.水力旋流器分离理论的研究与发展趋势[J].流体机械,2005,33(7):36-40. [10] 王海刚,刘石.不同湍流模型在旋风分离器三维数值模拟中的应用和比较[J].热能动力工程,2003,18(4):337-342. [11] SONG T,TIAN J Y,NI L,et al.Experimental study on liquid flow fields in de-foulant hydrocyclones with reflux ejector using particle image velocimetry[J].Separation and Purification Technology,2020,240:116555. [12] SONG T,TIAN J Y,NI L,et al.Experimental study on performance of a de-foulant hydrocyclone with different reflux devices for sewage source heat pump[J].Applied Thermal Engineering,2019,149:354-365. [13] JIANG L Y,LIU P K,YANG X H,et al.Experimental research on the separation performance of W-shaped hydrocyclone[J].Powder Technology,2020,372:532-541. [14] JIANG L Y,LIU P K,ZHANG Y K,et al.Design boundary layer structure for improving the particle separation performance of a hydrocyclone[J].Powder Technology,2019,350:1-14. [15] SUN Y X,LIU Y,ZHANG Y H,et al.Hydrocyclone-induced pretreatment for sludge solubilization to enhance anaerobic digestion[J].Chemical Engineering Journal,2019,374:1364-1372. [16] XU J P,SUN Y X,LIU Y,et al.In-situ sludge settleability improvement and carbon reuse in SBR process coupled with hydrocyclone[J].Science of The Total Environment,2019,695:133825. [17] LIU Y,WAND H L,XU Y X,et al.Sludge disintegration using a hydrocyclone to improve biological nutrient removal and reduce excess sludge[J].Separation and Purification Technology,2017,177:192-199. [18] PECAREVIC M,MIKUS J,PRUSINA I,et al.New role of hydrocyclone in ballast water treatment[J].Journal of Cleaner Production,2018,188:339-346. [19] 陈进富.油田采出水处理技术与进展[J].环境工程,2000,18(1):18-20. [20] GOROBETS A V,TARABARA V V.Separation performance of desanding and deoiling hydrocyclones treating three-phase feeds:effect of oil-particle aggregates[J].Separation and Purification Technology,2020,237:116466. [21] LV W J,DANG Z H,HE Y,et al.UU-type parallel mini-hydrocyclone group for oil-water separation in methanol-to-olefin industrial wastewater[J].Chemical Engineering and Processing-Process Intensification,2020,149:107846. [22] GOLMAEI M,KINNARINEN T,JERNSTROM E,et al.Efficient separation of hazardous trace metals and improvement of the filtration properties of green liquor dregs by a hydrocyclone[J].Journal of cleaner production,2018,183:162-171. [23] 徐晓军,韦韬,魏艳平.通沟污泥处理技术的发展[J].环境生态学,2020,2(8):82-88. [24] LIU L,ZHAO L X,YANG X,et al.Innovative design and study of an oil-water coupling separation magnetic hydrocyclone[J].Separation and Purification Technology,2019,213:389-400.
点击查看大图
计量
- 文章访问数: 692
- HTML全文浏览量: 58
- PDF下载量: 19
- 被引次数: 0