CFD数值模拟在两级串塔脱硫系统中的应用

聂鹏飞; 高志; 孟德润; 张宏博; 张晴

doi:10.13205/j.hjgc.202108016

CFD数值模拟在两级串塔脱硫系统中的应用

doi: 10.13205/j.hjgc.202108016

1. 河北大唐国际王滩发电有限责任公司, 河北唐山 063611;
2. 唐山学院, 河北唐山 063020;
3. 福思力智科技(北京)有限公司, 北京 100020

详细信息

作者简介:
聂鹏飞,男,高级工程师,主要从事火电厂脱硫技术监督与设备管理。daniao433@163.com

计量
- 文章访问数: 164
- HTML全文浏览量: 27
- PDF下载量: 10
- 被引次数: 0
出版历程
- 收稿日期: 2020-12-28
- 网络出版日期: 2022-01-18

APPLICATION OF CFD IN A DOUBLE STAGE DESULFURIZATION SYSTEM

1. Hebei Datang International Wangtan Power Generation Co., Ltd, Tangshan 063611, China;
2. Tangshan University, Tangshan 063020, China;
3. FORCE Technology(Beijing) Co., Ltd, Beijing 100020, China

摘要

摘要: 为准确获取两级串塔脱硫系统的气液两相反应特点，采用分步法和自主开发的托盘模型对某电厂双塔串联湿法脱硫塔喷淋段内部的气液两相流动和传热过程进行CFD数值模拟，采用全新的系统评价指标对脱硫系统进行评估，对脱硫系统进行优化设计并重新进行数值模拟评估。计算结果表明：无论预洗塔和吸收塔，通过合理增加托盘和增效环的设计，可以在减少1层喷淋层的基础上获得更佳的性能，有利于达到更高的脱硫标准；减少循环浆液量的同时能够降低脱硫塔整个系统压降，降低电耗。
- 烟气脱硫 /
- 数值模拟 /
- 托盘子模型 /
- 脱硫塔优化设计
Abstract: In order to accurately obtain the gas-liquid two-phase reaction characteristics of the two-stage series tower desulfurization system, the gas-liquid two-phase flow and heat transfer process in the spray section of the double tower series wet desulfurization tower in a power plant were numerically simulated by using the step-by-step method and the self-developed tray model. A new system evaluation index was used to evaluate the desulfurization system, and the desulfurization system was optimized and evaluated by numerical simulation. The calculation results showed that no matter the pre washing tower or the absorption tower, the design of adding tray and efficiency ring reasonably could obtain better performance on the basis of opening less spray layer, which was conducive to reaching the higher standard of desulfurization, and reducing the amount of circulating slurry as well as reducing the pressure drop of the whole system of desulfurization tower and the power consumption.
- flue gas desulfurization /
- numerical simulation /
- tray model /
- optimization design of desulfurization tower

HTML全文

参考文献(9)

[1]	林瑜,陈德珍,尹丽洁.喷淋层组合方式对大型脱硫塔内流动和热湿交换过程影响的数值模拟[J].中南大学学报(自然科学版),2017,48(10):2572-2581.
[2]	钟毅,高翔,王惠挺,等.基于CFD技术的湿法烟气脱硫系统性能优化[J].中国电机工程学报,2008,28(32):18-23.
[3]	MAROCCO L,INZOLI F.Multiphase Euler-Lagrange CFD simulation applied to wet flue gas desulphurisation technology[J].International Journal of Multiphase Flow,2009,35(2):185-194.
[4]	ZHENG M Q,HU H,ZHANG G X,et al.Combination of adsorption-diffusion model with CFD for study of desulfurization in fixed bed[J].Journal of Environmental Chemical Engineering,2017,5(4):4141-4150.
[5]	吴一帆,王宏利,秦明臣,等.托盘式湿法烟气脱硫塔阻力特性研究[J].中国煤炭,2020,46(4):70-76.
[6]	HOFELSAUER J,NOTTER W,MAROCCO L,et al.Improvement of SO₂ removal with application of wall rings and advanced CFD modeling:the case of FGD unit Megalopolis[J].VGB Power Technology,2008,3:85-89.
[7]	郭健.任丘电厂湿法脱硫双塔串联系统改造研究及应用[D].保定:华北电力大学(保定),2018.
[8]	林瑜,陈德珍.大型脱硫塔喷淋段气液两相流动与传热的数值仿真及验证[J].燃烧科学与技术,2016,22(1):5-12.
[9]	TSENG C C,LI C J.Eulerian-Eulerian numerical simulation for a flue gas desulfurization tower with perforated sieve trays[J].International Journal of Heat and Mass Transfer,2018,116:329-345.