PREPARATION OF STAINLESS STEEL-BASED Sb-SnO2/PbO2 ELECTRODE AND EFFECT OF ELECTRODEPOSITION FACTORS ON ITS PERFORMANCE
-
摘要: 以316L不锈钢为基体,制备了一种以锑掺杂二氧化锡(Sb-SnO2)为中间层的不锈钢基二氧化铅(PbO2)电极,用于对酸性红G(ARG)的脱色处理。利用扫描电镜(SEM)、X-射线衍射(XRD)、强化寿命测试、线性扫描测试(LSV)等方法对所制备电极的表观形貌、晶体结构、稳定性和催化性能等进行表征。在此基础上,采用正交实验优化对电极稳定性影响较大的4种典型因素(铅离子浓度、温度、电流密度和电沉积时间)。结果表明:在不锈钢基体上成功制备出了β-PbO2层,其形貌为典型的β-PbO2锥形结构;强化寿命测试结果表明不同于钛基氧化物电极的均匀腐蚀,不锈钢基PbO2电极的失效机制主要为点蚀;采用LSV测试、羟基自由基(·OH)产量测试和电催化降解测试证明了正交实验优化条件后的不锈钢基PbO2电极具有较好的催化性能。不锈钢基PbO2电极的成功制备有望为电催化氧化阳极材料的改性方法提供新思路。Abstract: In this paper, the stainless steel-based lead dioxide (PbO2) electrode with antimony-doped tin dioxide (Sb-SnO2) interlayer was prepared using 316L stainless steel as the substrate, and used for the decolorization of Acid Red G (ARG). The morphology, crystal structure, stability and catalytic performance of the electrode were characterized by scanning electron microscopy (SEM), X-ray diffraction (XRD), enhanced lifetime test, and linear scan test (LSV). Based on this, orthogonal experiments were used to optimize four typical factors (lead ion concentration, temperature, current density and electrodeposition time) that had a strong influence on stability of the electrode. The results showed that the β-PbO2 layer was successfully prepared on the stainless steel substrate with a typical conical structure of β-PbO2 in its morphology. The results of the enhanced lifetime test indicated that the failure mechanism of the stainless steel-based PbO2 electrode was mainly pitting corrosion, which was different from the uniform corrosion of the titanium-based oxide electrode. The LSV test, hydroxyl radical (·OH) yield test and electrocatalytic degradation test were used to demonstrate the better catalytic performance of the stainless steel-based PbO2 electrode, after optimizing the conditions in orthogonal experiments. The successful preparation of stainless steel-based PbO2 electrode is expected to provide a new choice for electrocatalytic oxidation anode materials.
-
Key words:
- PbO2 electrode /
- stainless steel base /
- electrodeposition /
- orthogonal experiment /
- catalytic activity
-
[1] 胡承志, 刘会娟, 曲久辉. 电化学水处理技术研究进展[J]. 环境工程学报, 2018, 12(3): 677-696. [2] 叶国杰, 王一显, 罗培, 等. 水处理高级氧化法活性物种生成机制及其技术特征分析[J]. 环境工程, 2020, 38(2): 1-15. [3] 徐浩, 乔丹, 许志成, 等. 电催化氧化技术在有机废水处理中的应用[J]. 工业水处理, 2021, 41(3): 1-9. [4] 刘明康, 周键, 王三反, 等. Ce修饰Ti/PbO2阳极电催化氧化降解苯酚的研究[J]. 环境科学与管理, 2017, 42(7): 75-79. [5] 袁孟孟, 傅鸿宣, 乔丹, 等. Fe3O4/TiOx磁性颗粒构建的2.5维电极及其电催化性能[J]. 工业水处理, 2021, 41(1): 71-76. [6] BI Q, ZHANG Z K, SUN Y F, et al. Preparation and performance of highly active and long-life mesopore Ti/SnO2-Sb electrodes for electrochemical degradation of phenol[J]. Journal of Alloys and Compounds, 2021, 889: 161657. [7] 李晓良, 徐浩, 延卫. 高效Ti/PbO2电极制备及对酸性红G的降解研究[J]. 中国环境科学, 2017, 37(7): 2591-2598. [8] 唐长斌, 王飞, 牛浩, 等. 引入电弧喷涂氮化锆中间层的钛基PbO2的电催化阳极性能[J]. 材料研究学报, 2020, 34(7): 527-534. [9] GUO H, XU Z C, WANG D, et al. Evaluation of diclofenac degradation effect in "active" and "non-active" anodes: a new consideration about mineralization inclination[J]. Chemosphere, 2022, 286: 131580. [10] 岳文清, 倪月, 孙则朋, 等. 改性钛基PbO2电极对有机污染物的降解性能:以甲基橙和4-硝基苯酚为例[J]. 中国环境科学, 2022, 42(2): 706-716. [11] DONG H, HU X Y, ZHANG Y H, et al. Co/La modified Ti/PbO2 anodes for chloramphenicol degradation: catalytic performance and reaction mechanism[J]. Chemosphere, 2021, 285: 131568. [12] 李佳欣, 陈野, 韩洪军, 等. 钛基PbO2电极制备及其电催化处理煤化工废水[J]. 中国给水排水, 2019, 35(3): 111-116. [13] 董艳杰, 林海波, 陈碧芬. 苯酚电化学氧化过程中Ti/PbO2阳极钝化现象的研究[J]. 云南化工, 2021, 48(3): 55-58. [14] 李献民, 刘立, 董洁, 等. 钛及钛合金材料经济性及低成本方法论述[J]. 中国材料进展, 2015, 34(5): 401-406. [15] KITTE S A, ZAFAR M N, ZHOLUDOV Y T, et al. Determination of concentrated hydrogen peroxide free from oxygen interference at stainless steel electrode[J]. Analytical chemistry, 2018, 90(14): 8680-8685. [16] 杜重麟, 桂来, 李芬锐, 等. 不锈钢基ZnO/PbO2阵列电极的制备及其析氧电催化性能[J]. 电镀与涂饰, 2021, 40(21): 1659-1665. [17] 徐浩, 延卫, 游莉. 不同酸处理对钛基体性能的影响[J]. 稀有金属材料与工程, 2011, 40(9): 1550-1554. [18] 丁奇, 王建凤, 王颖, 等. MIL-88A光芬顿催化体系中羟基自由基的检测[J]. 分析仪器, 2021(4): 132-138. [19] 杨卫华, 王鸿辉, 付芳, 等. 电沉积条件对Ti/Sb-SnO2/β-PbO2电极性能的影响[J]. 华侨大学学报(自然科学版), 2010, 31(3): 297-301. [20] 李会喜, 崔文蓉, 朱薇, 等. 电流密度对Ti/β-PbO2-WC复合电极材料在电解锌液中耐蚀性影响研究[J]. 化学研究与应用, 2018, 30(2): 226-230. [21] 杜炳谦, 陈阵, 余强, 等. 温度对Ti/β-PbO2-WC复合电极材料耐蚀性的影响[J]. 材料保护, 2017, 50(5): 42-44,63. [22] TAN X D, MA L, HAN P W, et al. Fabrication of boron-doped diamond films electrode for efficient electrocatalytic degradation of cresols[J]. Chemosphere, 2020, 246: 125786. [23] 李晓良, 徐浩, 延卫. 十二烷基二甲基甜菜碱对Ti/PbO2电极的改性研究[J]. 西安交通大学学报, 2017, 51(5): 142-148. [24] GUO H, XU Z C, QIAO D, et al. Fabrication and characterization of titanium-based lead dioxide electrode by electrochemical deposition with Ti4O7 particles[J]. Water Environment Research, 2021, 93: 42-50. [25] ZHANG R R, HUA S G, DANG Y, et al. Strategy for enhancing the electrocatalytic performance of Ti/β-PbO2 anode: optimizing SnO2 intermediate layer by Cs doping and application for the efficient removal of mixed fluoroquinolones[J]. Journal of Alloys and Compounds, 2022, 895: 162528. [26] 王鸿辉, 杨卫华, 黄龙, 等. Ti/α-PbO2/β-PbO2电极电催化氧化处理苯酚废水[J]. 华侨大学学报(自然科学版), 2008,29(2): 263-266. [27] QIAO D, XU Z C, GUO H, et al. Non-traditional power supply mode: investigation of electrodeposition towards a better understanding of PbO2 electrode for electrochemical wastewater treatment[J]. Materials Chemistry and Physics, 2022, 284: 126066. [28] XUE J Q, MA S W, BI Q, et al. Comparative study on the effects of different structural Ti substrates on the properties of SnO2 electrodes[J]. Journal of Alloys and Compounds, 2018, 773: 1040-1047. [29] 徐浩, 邵丹, 杨鸿辉, 等. Ti/Sb-SnO2电极电解后的表面状态变化[J]. 西安交通大学学报, 2014, 48(2): 93-98. [31] 李鹏, 赵跃民, 王立章, 等. β-PbO2/Sb-SnO2/Ti电极的苯酚电催化性能研究[J]. 电化学, 2014, 20(5): 493-498. [32] 徐浩,郭午琪,王晓璇,等. 超声对二氧化铅电极性质的影响[J]. 西安交通大学学报,2015, 49(7): 82-87,148. [33] 徐浩,张倩,邵丹,等. 钛基体锑掺杂二氧化锡电极的制备与改性研究进展[J]. 化工进展, 2013, 32(增刊1): 145-151. [34] CHEN Y, HONG L, XUE H M, et al. Preparation and characterization of TiO2-NTs/SnO2-Sb electrodes by electrodeposition[J]. Journal of Electroanalytical Chemistry, 2010, 648(2): 119-127. [35] ZHANG Z K, WANG Z Y, SUN Y F, et al. Preparation of a novel Ni/Sb co-doped Ti/SnO2 electrode with carbon nanotubes as growth template by electrodeposition in a deep eutectic solvent[J]. Journal of Electroanalytical Chemistry, 2022, 911: 116225. [36] YU L H, XUE J Q, ZHANG L H, et al. Fabrication of a stable Ti/Pb-TiO<em>xNWs/PbO2 anode and its application in benzoquinone degradation[J]. Electrochimica Acta, 2021, 368: 137532. [37] YUAN M M, SALMAN N M, GUO H, et al. A 2.5D electrode system constructed of magnetic Sb-SnO2 particles and a PbO2 electrode and its electrocatalysis application on Acid Red G degradation[J]. Catalysts, 2019, 9(11): 875.XU H, YAN W, YANG H H. Surface analysis of Ti/Sb-SnO2/PbO2 electrode after long time electrolysis[J]. Rare Metal Materials and Engineering, 2015, 44(11): 2637-2641. [30]
点击查看大图
计量
- 文章访问数: 163
- HTML全文浏览量: 17
- PDF下载量: 11
- 被引次数: 0